密相塔半干法烟气脱硫塔内加湿降温及其对脱硫效率的影响

为了实现密相塔半干法脱硫工艺的精确加湿进一步提高系统脱硫效率,利用推导出的传热传质计算方法,得到烟气温度降低和加水量的关系.结合3组密相塔半干法工程实际数据,发现理论计算值和实测值误差区间仅为2.9％ ～5.4％.通过选取河北某钢厂210 m2烧结烟气密相塔半干法脱硫项目实际在线检测数据,发现循环脱硫灰含湿量为3％的系统脱硫效率整体高于含湿量为5％和4％的样品,最大值达93.56％.通过粒度分析、扫描电镜、X射线衍射及差热-热重对2种不同含湿量的循环脱硫灰进行表征,结果表明,含湿量为3％的循环脱硫灰较含湿量为5％的样品粒径小、比表面积大,无团聚现象,物相分析还证实相对于含湿量为5％样品,其Ca(OH)2和结晶水含量少,几乎都是CaSO4和CaS03干态物质,因此脱硫反应进行彻底,脱硫效率较高.     

Stability of a Coal Waste Artificial Reef

The feasibility of using U.K. coal-fired power station waste materials for artificial reef production is being examined. in June, 1989, an experimental artificial reef was constructed in Poole Bay, off the central south coast of the U.K., using three different mixtures of pulverised fuel ash (PFA), flue gas desulphurisation (FGD) gypsum and slurry, stabilized with cement and formed into blocks. Fifty tonnes of 40 × 20 × 20 cm blocks were formed into eight conical reef units replicating three different PFA/gypsum mixtures and one concrete control. the reef structure is 10m below chart datum on a flat sandy sea-bed.

Combustion of coal concentrates the heavy metal content in the resultant ash. the purpose of stabilization of the ash as blocks is twofold: to immobilize heavy metals (or other components) and to provide hard substratum for the attachment of organisms. to examine the effectiveness of this stabilization and hence the environmental compatibility of the block materials, heavy metal (Cd, Cr, Cu, Pb, Mn, Ni, Zn) content of the blocks has been monitored routinely over two years, to determine leaching rates. Sectional profiles indicate partial replacement of calcium content by magnesium. Associated with this there has also been some redistribution of heavy metals. Only in the case of cadmium has there been a detectable loss from the surface of blocks. Chromium and manganese concentrations appear to have increased. the metal content of the reef epibiota (including ascidians, Ascidia mentula; hydroids, Halecium spp.; bryozoans, Bugula spp. and red algae) growing on the ash blocks has been compared to that of epibiota attached to the concrete controls and surrounding sea-bed. to date no evidence of excess bioaccumulation of metals has been detected.

The physical integrity of the ash reef blocks has been maintained. There is evidence that the blocks are increasing in compressive strength.

An indication of the fishery enhancement potential of the experimental structure is given by the presence of eight commercially fished species (crustaceans and molluscs) including lobsters (Homarus gammarus).     

焚烧飞灰重金属含量及浸出长期变化规律研究

通过对24个飞灰样品的重金属全量消解和高精度X射线荧光光谱法（HDXRF）快速检测结果进行线性回归分析,发现HDXRF法可较准确测定飞灰中Cu、Pb、Zn、Ni和Cd含量（线性回归决定系数R²³0.90）.采用HDXRF法对某焚烧厂飞灰重金属含量6个月快速检测及浸出毒性测定数据统计分析发现：飞灰重金属月均含量较稳定（变异系数CV<0.14）但日均含量波动较大（CV>2.54）;飞灰中Pb、Cu和Zn含量呈正相关（相关系数r>0.78）;金属浸出浓度受浸出液终点pH值影响显著,超标频率依次为Pb（68.9%）、Cd（66.1%）、Ni（24.0%）、Cu（14.2%）和Zn（1.6%）.短期飞灰金属含量和浸出毒性数据受焚烧工况,烟气处理工况和垃圾组分等多种因素共同影响,不具有代表性.为评估垃圾分类源头削减重金属效果,建议采用快速检测方法对焚烧飞灰重金属含量进行长期监测.     

Coupling mechanism of activated carbon mixed with dust for flue gas desulfurization and denitrification

To clarify the effect of coking dust, sintering dust and fly ash on the activity of activated carbon for various industrial flue gas desulfurization and denitrification, the coupling mechanism of the mixed activated carbon and dust was investigated to provide theoretical reference for the stable operation. The results show that coking dust had 34% desulfurization efficiency and 10% denitrification efficiency; correspondingly, sintering dust and fly ash had no obvious desulfurization and denitrification activities. For the mixture of activated carbon and dust, the coking dust reduced the desulfurization and denitrification efficiencies by blocking the pores of activated carbon, and its inhibiting effect on activated carbon was larger than its own desulfurization and denitrification activity. The sintering dust also reduced the desulfurization efficiency on the activated carbon while enhancing the denitrification efficiency. Fly ash blocked the pores of activated carbon and reduced its reaction activity. The reaction activity of coking dust mainly came from the surface functional groups, similar to that of activated carbon. The reaction activity of sintering dust mainly came from the oxidative property of Fe₂O₃, which oxidized NO to NO₂ and promoted the fast selectively catalytic reduction (SCR) of NO to form N₂. Sintering dust was activated by the joint action of activated carbon, and both had a coupling function. Sintering dust enhanced the adsorption and oxidation of NO, and activated carbon further promoted the reduction of NO_x by NH₃; thus, the denitrification efficiency increased by 5%-7% on the activated carbon.     

不同裂解温度稻壳生物炭对阿特拉津的吸附行为及机制

为探究不同裂解温度下稻壳生物炭的结构和性质差异及其对阿特拉津（AT）的吸附作用机制和构-效关系,以稻壳为原料在300、500和700℃下制备稻壳生物炭（分别记为RH300、RH500、RH700）,通过电镜扫描、元素分析仪、比表面积分析仪和傅里叶变换红外光谱分析仪等对3种稻壳生物炭进行结构表征分析,并采用批量等温吸附法研究稻壳生物炭对AT的吸附特性.结果表明:裂解温度由300℃升至700℃时,稻壳生物炭中w（C）由48.81%升至64.67%,w（H）、w（N）和w（O）则由3.22%、1.45%和34.66%分别降至0.89%、0.92%和16.29%,原子比H/C、O/C和（O+N）/C值均降低.可见,随着裂解温度升高,稻壳生物炭的芳香性增强,亲水性和极性降低,且比表面积和孔体积增大,平均孔径减小.3种稻壳生物炭对AT的吸附均可用Freundlich和Langmuir两种等温吸附模型进行较好地拟合（R≥0.948,P < 0.01）,吸附作用及非线性程度与生物炭的比表面积（SSA）、芳香性（H/C）、亲水性（O/C）和极性〔（O+N）/C〕呈良好的指数关系,大小表现为RH700 > RH500 > RH300.稻壳生物炭对AT的吸附机制主要包括分配作用和表面吸附,分配作用强度与生物炭的极性和炭化程度有关;而表面吸附作用与AT的分子大小有关,3种稻壳生物炭对AT的表面吸附除表面覆盖外,还存在多层平铺、毛细管现象和孔隙填充等.研究显示,裂解温度是影响生物炭吸附有机污染物的重要因素,在综合考虑成本和制备工艺的同时,适当提高裂解温度可增强生物炭对有机污染物的吸附作用.      

Fly-ash-induced oxidative stress and tolerance in Prosopis juliflora L. grown on different amended substrates

Field experiments were conducted to study the impact of metal accumulation on malondialdehyde (MDA), cysteine and non-protein thiol (NPSH) contents in the plants of Prosopis juliflora grown on the fly ash (FA) amended with soil, blue green algae (BGA) biofertilizer, farm yard manure, press mud and Rhizobium inoculation. The analysis of data revealed that the level of MDA, cysteine and NPSH was higher in the roots of the plant than leaves, which was found positively correlated with metal accumulation. An increase of 361.14, 64.25 and 305.62% in MDA, cysteine and NPSH contents, respectively was observed after 45 days in the roots of the plants grown in 100% FA as compared to 100% garden soil (GS). The level of MDA, cysteine and NPSH was found less in the plants grown on various amendments of FA showing ameliorating effect on the toxicity induced due to the accumulation of metals. The decrease in MDA, cysteine and NPSH contents was higher in Rhizobium-inoculated plants as compared to uninoculated plants grown on 100% FA. The results showed a high tolerance potential of the plant, which is further increased by inoculating the plant with FA-tolerant Rhizobium showing feasibility of using P. juliflora in environmental monitoring of FA landfills.     

Pyrolysis of rice husk and sawdust for liquid fuel

The paper is focused on studying how to convert rice husk and sawdust into liquid fuel. Rice husk, sawdust and their mixture were pyrolyzed at the temperature between 420℃ and 540℃, and the main product of liquid fuel was obtained. The experimental result showed that the yield of liquid fuel heavily depended on the kind of feedstock and pyrolysis temperature. In the experiments, the maximum liquid yields for rice husk, sawdust and their mixture were 56% at 465 ℃, 61% at 490℃ and 60% at 475℃ respectively. Analysis with GC-MS and other apparatus indicated that the liquid fuel is a complicated organic compound with low caloric value and can be directly used as fuel oil without any up-grading. As a crude oil, the liquid fuel can be refined to be vehicle oil.     

CFB锅炉燃烧高硫石油焦的灰渣综合利用研究

循环流化床锅炉在燃烧含硫石油焦时,通过加入石灰石在燃烧的过程中以固态的形式脱硫,燃烧后将产生大量的灰渣,过去处理灰渣最通常的方式是作土地填埋。从灰渣的化学、物理特性试验研究出发,寻找循环流化床灰渣在建筑材料、农业应用和水泥添加剂方面的利用途径,研究了更加经济有效的灰渣处理方法。     

粉煤灰预处理及其对染料单体脱色效果的研究

介绍了一种粉煤灰预处理的方法-用8mol/L的H2SO4处理，可较好地改善其表面状况，并用预处理后的粉煤灰对染料单体进行脱色试验，寻找了最佳的处理方案，脱色效果较好，建立了Langmuir吸附等温模型。探讨了其脱色机理，为实际开发利用粉煤灰处理印染废水提供基础研究。     

粉煤灰/工业污泥烧结陶粒的制备与应用

以粉煤灰和工业污水处理站的剩余污泥为主要原材料，采用烧结法研制复合陶粒。分析了不同配方和不同烧结温度对陶粒性能的影响，以陶粒吸水率．容重为评价指标确定最佳配比和最佳烧结温度。提出用陶粒铺设景观水底，治理城市水体．并对其进行了可行性分析。粉煤灰／污泥陶粒的容重为0．79～0．9g／cm^3，吸水率为68．95％-80．01％。陶粒对水中氨氮和总磷吸附容量分别为0．03～0．05mg／g和0．01-0.02mg／g。